driver will print ACPI tables for AMD IOMMU during
IOMMU initialization.
+ amd_iommu_intr= [HW,X86-64]
+ Specifies one of the following AMD IOMMU interrupt
+ remapping modes:
+ legacy - Use legacy interrupt remapping mode.
+ vapic - Use virtual APIC mode, which allows IOMMU
+ to inject interrupts directly into guest.
+ This mode requires kvm-amd.avic=1.
+ (Default when IOMMU HW support is present.)
+
amijoy.map= [HW,JOY] Amiga joystick support
Map of devices attached to JOY0DAT and JOY1DAT
Format: <a>,<b>
intel_idle.max_cstate= [KNL,HW,ACPI,X86]
0 disables intel_idle and fall back on acpi_idle.
- 1 to 6 specify maximum depth of C-state.
+ 1 to 9 specify maximum depth of C-state.
intel_pstate= [X86]
disable
than or equal to this physical address is ignored.
maxcpus= [SMP] Maximum number of processors that an SMP kernel
- should make use of. maxcpus=n : n >= 0 limits the
- kernel to using 'n' processors. n=0 is a special case,
- it is equivalent to "nosmp", which also disables
- the IO APIC.
+ will bring up during bootup. maxcpus=n : n >= 0 limits
+ the kernel to bring up 'n' processors. Surely after
+ bootup you can bring up the other plugged cpu by executing
+ "echo 1 > /sys/devices/system/cpu/cpuX/online". So maxcpus
+ only takes effect during system bootup.
+ While n=0 is a special case, it is equivalent to "nosmp",
+ which also disables the IO APIC.
max_loop= [LOOP] The number of loop block devices that get
(loop.max_loop) unconditionally pre-created at init time. The default
nodelayacct [KNL] Disable per-task delay accounting
- nodisconnect [HW,SCSI,M68K] Disables SCSI disconnects.
-
nodsp [SH] Disable hardware DSP at boot time.
noefi Disable EFI runtime services support.
nr_cpus= [SMP] Maximum number of processors that an SMP kernel
could support. nr_cpus=n : n >= 1 limits the kernel to
- supporting 'n' processors. Later in runtime you can not
- use hotplug cpu feature to put more cpu back to online.
- just like you compile the kernel NR_CPUS=n
+ support 'n' processors. It could be larger than the
+ number of already plugged CPU during bootup, later in
+ runtime you can physically add extra cpu until it reaches
+ n. So during boot up some boot time memory for per-cpu
+ variables need be pre-allocated for later physical cpu
+ hot plugging.
nr_uarts= [SERIAL] maximum number of UARTs to be registered.
raid= [HW,RAID]
See Documentation/md.txt.
+ ram_latent_entropy
+ Enable a very simple form of latent entropy extraction
+ from the first 4GB of memory as the bootmem allocator
+ passes the memory pages to the buddy allocator.
+
ramdisk_size= [RAM] Sizes of RAM disks in kilobytes
See Documentation/blockdev/ramdisk.txt.