Commit | Line | Data |
---|---|---|
236db47c BP |
1 | What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode |
2 | Date: March 2010 | |
3 | Contact: Bruno Prémont <bonbons@linux-vserver.org> | |
4 | Description: Make it possible to switch the PicoLCD device between LCD | |
5 | (firmware) and bootloader (flasher) operation modes. | |
6 | ||
7 | Reading: returns list of available modes, the active mode being | |
8 | enclosed in brackets ('[' and ']') | |
9 | ||
10 | Writing: causes operation mode switch. Permitted values are | |
0b5adf92 | 11 | the non-active mode names listed when read. |
236db47c BP |
12 | |
13 | Note: when switching mode the current PicoLCD HID device gets | |
0b5adf92 BP |
14 | disconnected and reconnects after above delay (see attribute |
15 | operation_mode_delay for its value). | |
16 | ||
17 | ||
18 | What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/operation_mode_delay | |
19 | Date: April 2010 | |
20 | Contact: Bruno Prémont <bonbons@linux-vserver.org> | |
21 | Description: Delay PicoLCD waits before restarting in new mode when | |
22 | operation_mode has changed. | |
23 | ||
24 | Reading/Writing: It is expressed in ms and permitted range is | |
25 | 0..30000ms. | |
236db47c | 26 | |
b8c21cf6 BP |
27 | |
28 | What: /sys/bus/usb/devices/<busnum>-<devnum>:<config num>.<interface num>/<hid-bus>:<vendor-id>:<product-id>.<num>/fb_update_rate | |
29 | Date: March 2010 | |
30 | Contact: Bruno Prémont <bonbons@linux-vserver.org> | |
31 | Description: Make it possible to adjust defio refresh rate. | |
32 | ||
33 | Reading: returns list of available refresh rates (expressed in Hz), | |
34 | the active refresh rate being enclosed in brackets ('[' and ']') | |
35 | ||
36 | Writing: accepts new refresh rate expressed in integer Hz | |
37 | within permitted rates. | |
38 | ||
39 | Note: As device can barely do 2 complete refreshes a second | |
40 | it only makes sense to adjust this value if only one or two | |
41 | tiles get changed and it's not appropriate to expect the application | |
08559657 | 42 | to flush its tiny changes explicitly at higher than default rate. |
b8c21cf6 | 43 |