Commit | Line | Data |
---|---|---|
790edb61 G |
1 | config UNICORE32 |
2 | def_bool y | |
3 | select HAVE_MEMBLOCK | |
4 | select HAVE_GENERIC_DMA_COHERENT | |
5 | select HAVE_GENERIC_HARDIRQS | |
6 | select HAVE_DMA_ATTRS | |
7 | select HAVE_KERNEL_GZIP | |
8 | select HAVE_KERNEL_BZIP2 | |
82e54a6a | 9 | select GENERIC_ATOMIC64 |
790edb61 G |
10 | select HAVE_KERNEL_LZO |
11 | select HAVE_KERNEL_LZMA | |
7563bbf8 | 12 | select ARCH_HAVE_CUSTOM_GPIO_H |
790edb61 G |
13 | select GENERIC_FIND_FIRST_BIT |
14 | select GENERIC_IRQ_PROBE | |
37daf322 | 15 | select GENERIC_IRQ_SHOW |
790edb61 | 16 | select ARCH_WANT_FRAME_POINTERS |
4673ca8e | 17 | select GENERIC_IOMAP |
786d35d4 | 18 | select MODULES_USE_ELF_REL |
790edb61 G |
19 | help |
20 | UniCore-32 is 32-bit Instruction Set Architecture, | |
21 | including a series of low-power-consumption RISC chip | |
22 | designs licensed by PKUnity Ltd. | |
23 | Please see web page at <http://www.pkunity.com/>. | |
24 | ||
790edb61 G |
25 | config GENERIC_GPIO |
26 | def_bool y | |
27 | ||
790edb61 G |
28 | config GENERIC_CSUM |
29 | def_bool y | |
30 | ||
31 | config NO_IOPORT | |
32 | bool | |
33 | ||
34 | config STACKTRACE_SUPPORT | |
35 | def_bool y | |
36 | ||
37 | config HAVE_LATENCYTOP_SUPPORT | |
38 | def_bool y | |
39 | ||
40 | config LOCKDEP_SUPPORT | |
41 | def_bool y | |
42 | ||
43 | config RWSEM_GENERIC_SPINLOCK | |
44 | def_bool y | |
45 | ||
46 | config RWSEM_XCHGADD_ALGORITHM | |
47 | bool | |
48 | ||
49 | config ARCH_HAS_ILOG2_U32 | |
50 | bool | |
51 | ||
52 | config ARCH_HAS_ILOG2_U64 | |
53 | bool | |
54 | ||
55 | config ARCH_HAS_CPUFREQ | |
56 | bool | |
57 | ||
58 | config GENERIC_HWEIGHT | |
59 | def_bool y | |
60 | ||
61 | config GENERIC_CALIBRATE_DELAY | |
62 | def_bool y | |
63 | ||
64 | config ARCH_MAY_HAVE_PC_FDC | |
65 | bool | |
66 | ||
446d141e GX |
67 | config ZONE_DMA |
68 | def_bool y | |
69 | ||
790edb61 G |
70 | config NEED_DMA_MAP_STATE |
71 | def_bool y | |
72 | ||
73 | source "init/Kconfig" | |
74 | ||
75 | source "kernel/Kconfig.freezer" | |
76 | ||
77 | menu "System Type" | |
78 | ||
79 | config MMU | |
80 | def_bool y | |
81 | ||
82 | config ARCH_FPGA | |
83 | bool | |
84 | ||
85 | config ARCH_PUV3 | |
86 | def_bool y | |
87 | select CPU_UCV2 | |
88 | select GENERIC_CLOCKEVENTS | |
89 | select HAVE_CLK | |
90 | select ARCH_REQUIRE_GPIOLIB | |
91 | select ARCH_HAS_CPUFREQ | |
92 | ||
93 | # CONFIGs for ARCH_PUV3 | |
94 | ||
95 | if ARCH_PUV3 | |
96 | ||
97 | choice | |
98 | prompt "Board Selection" | |
99 | default PUV3_DB0913 | |
100 | ||
101 | config PUV3_FPGA_DLX200 | |
102 | select ARCH_FPGA | |
103 | bool "FPGA board" | |
104 | ||
105 | config PUV3_DB0913 | |
106 | bool "DEBUG board (0913)" | |
107 | ||
108 | config PUV3_NB0916 | |
109 | bool "NetBook board (0916)" | |
79c11b6f TR |
110 | select PWM |
111 | select PWM_PUV3 | |
790edb61 G |
112 | |
113 | config PUV3_SMW0919 | |
114 | bool "Security Mini-Workstation board (0919)" | |
115 | ||
116 | endchoice | |
117 | ||
118 | config PUV3_PM | |
119 | def_bool y if !ARCH_FPGA | |
120 | ||
121 | endif | |
122 | ||
123 | source "arch/unicore32/mm/Kconfig" | |
124 | ||
125 | comment "Floating poing support" | |
126 | ||
127 | config UNICORE_FPU_F64 | |
128 | def_bool y if !ARCH_FPGA | |
129 | ||
130 | endmenu | |
131 | ||
132 | menu "Bus support" | |
133 | ||
134 | config PCI | |
135 | bool "PCI Support" | |
136 | help | |
137 | Find out whether you have a PCI motherboard. PCI is the name of a | |
138 | bus system, i.e. the way the CPU talks to the other stuff inside | |
139 | your box. Other bus systems are ISA, EISA, MicroChannel (MCA) or | |
140 | VESA. If you have PCI, say Y, otherwise N. | |
141 | ||
142 | source "drivers/pci/Kconfig" | |
143 | ||
144 | source "drivers/pcmcia/Kconfig" | |
145 | ||
146 | endmenu | |
147 | ||
148 | menu "Kernel Features" | |
149 | ||
790edb61 G |
150 | source "kernel/Kconfig.preempt" |
151 | ||
152 | source "kernel/Kconfig.hz" | |
153 | ||
154 | source "mm/Kconfig" | |
155 | ||
156 | config LEDS | |
157 | def_bool y | |
158 | depends on GENERIC_GPIO | |
159 | ||
160 | config ALIGNMENT_TRAP | |
161 | def_bool y | |
162 | help | |
163 | Unicore processors can not fetch/store information which is not | |
164 | naturally aligned on the bus, i.e., a 4 byte fetch must start at an | |
165 | address divisible by 4. On 32-bit Unicore processors, these non-aligned | |
166 | fetch/store instructions will be emulated in software if you say | |
167 | here, which has a severe performance impact. This is necessary for | |
168 | correct operation of some network protocols. With an IP-only | |
169 | configuration it is safe to say N, otherwise say Y. | |
170 | ||
171 | endmenu | |
172 | ||
173 | menu "Boot options" | |
174 | ||
175 | config CMDLINE | |
176 | string "Default kernel command string" | |
177 | default "" | |
178 | ||
179 | config CMDLINE_FORCE | |
180 | bool "Always use the default kernel command string" | |
181 | depends on CMDLINE != "" | |
182 | help | |
183 | Always use the default kernel command string, even if the boot | |
184 | loader passes other arguments to the kernel. | |
185 | This is useful if you cannot or don't want to change the | |
186 | command-line options your boot loader passes to the kernel. | |
187 | ||
188 | If unsure, say N. | |
189 | ||
190 | endmenu | |
191 | ||
192 | menu "Userspace binary formats" | |
193 | ||
194 | source "fs/Kconfig.binfmt" | |
195 | ||
196 | endmenu | |
197 | ||
198 | menu "Power management options" | |
199 | ||
200 | source "kernel/power/Kconfig" | |
201 | ||
202 | if ARCH_HAS_CPUFREQ | |
203 | source "drivers/cpufreq/Kconfig" | |
204 | endif | |
205 | ||
206 | config ARCH_SUSPEND_POSSIBLE | |
207 | def_bool y if !ARCH_FPGA | |
208 | ||
209 | config ARCH_HIBERNATION_POSSIBLE | |
210 | def_bool y if !ARCH_FPGA | |
211 | ||
212 | endmenu | |
213 | ||
214 | source "net/Kconfig" | |
215 | ||
216 | if ARCH_PUV3 | |
217 | ||
218 | config PUV3_GPIO | |
219 | bool | |
220 | depends on !ARCH_FPGA | |
221 | select GENERIC_GPIO | |
c2844646 | 222 | select GPIO_SYSFS |
790edb61 G |
223 | default y |
224 | ||
fa7499ef G |
225 | if PUV3_NB0916 |
226 | ||
227 | menu "PKUnity NetBook-0916 Features" | |
228 | ||
229 | config I2C_BATTERY_BQ27200 | |
230 | tristate "I2C Battery BQ27200 Support" | |
8889023a | 231 | select I2C_PUV3 |
fa7499ef G |
232 | select POWER_SUPPLY |
233 | select BATTERY_BQ27x00 | |
234 | ||
235 | config I2C_EEPROM_AT24 | |
236 | tristate "I2C EEPROMs AT24 support" | |
8889023a | 237 | select I2C_PUV3 |
fa7499ef G |
238 | select EEPROM_AT24 |
239 | ||
240 | config LCD_BACKLIGHT | |
241 | tristate "LCD Backlight support" | |
242 | select BACKLIGHT_LCD_SUPPORT | |
243 | select BACKLIGHT_PWM | |
244 | ||
245 | endmenu | |
246 | ||
247 | endif | |
248 | ||
790edb61 G |
249 | endif |
250 | ||
251 | source "drivers/Kconfig" | |
252 | ||
253 | source "fs/Kconfig" | |
254 | ||
255 | source "arch/unicore32/Kconfig.debug" | |
256 | ||
257 | source "security/Kconfig" | |
258 | ||
259 | source "crypto/Kconfig" | |
260 | ||
261 | source "lib/Kconfig" |