Commit | Line | Data |
---|---|---|
3e074058 HCE |
1 | /* |
2 | * Copyright (C) 2007 Atmel Corporation | |
3 | * | |
4 | * Driver for the AT32AP700X PS/2 controller (PSIF). | |
5 | * | |
6 | * This program is free software; you can redistribute it and/or modify it | |
7 | * under the terms of the GNU General Public License version 2 as published | |
8 | * by the Free Software Foundation. | |
9 | */ | |
10 | ||
11 | #ifndef __INCLUDE_ATMEL_PWM_BL_H | |
12 | #define __INCLUDE_ATMEL_PWM_BL_H | |
13 | ||
14 | /** | |
15 | * struct atmel_pwm_bl_platform_data | |
16 | * @pwm_channel: which PWM channel in the PWM module to use. | |
17 | * @pwm_frequency: PWM frequency to generate, the driver will try to be as | |
18 | * close as the prescaler allows. | |
19 | * @pwm_compare_max: value to use in the PWM channel compare register. | |
20 | * @pwm_duty_max: maximum duty cycle value, must be less than or equal to | |
21 | * pwm_compare_max. | |
22 | * @pwm_duty_min: minimum duty cycle value, must be less than pwm_duty_max. | |
23 | * @pwm_active_low: set to one if the low part of the PWM signal increases the | |
24 | * brightness of the backlight. | |
25 | * @gpio_on: GPIO line to control the backlight on/off, set to -1 if not used. | |
26 | * @on_active_low: set to one if the on/off signal is on when GPIO is low. | |
27 | * | |
28 | * This struct must be added to the platform device in the board code. It is | |
29 | * used by the atmel-pwm-bl driver to setup the GPIO to control on/off and the | |
30 | * PWM device. | |
31 | */ | |
32 | struct atmel_pwm_bl_platform_data { | |
33 | unsigned int pwm_channel; | |
34 | unsigned int pwm_frequency; | |
35 | unsigned int pwm_compare_max; | |
36 | unsigned int pwm_duty_max; | |
37 | unsigned int pwm_duty_min; | |
38 | unsigned int pwm_active_low; | |
39 | int gpio_on; | |
40 | unsigned int on_active_low; | |
41 | }; | |
42 | ||
43 | #endif /* __INCLUDE_ATMEL_PWM_BL_H */ |