| 1 | # |
| 2 | # 1-wire slaves configuration |
| 3 | # |
| 4 | |
| 5 | menu "1-wire Slaves" |
| 6 | |
| 7 | config W1_SLAVE_THERM |
| 8 | tristate "Thermal family implementation" |
| 9 | help |
| 10 | Say Y here if you want to connect 1-wire thermal sensors to your |
| 11 | wire. |
| 12 | |
| 13 | config W1_SLAVE_SMEM |
| 14 | tristate "Simple 64bit memory family implementation" |
| 15 | help |
| 16 | Say Y here if you want to connect 1-wire |
| 17 | simple 64bit memory rom(ds2401/ds2411/ds1990*) to your wire. |
| 18 | |
| 19 | config W1_SLAVE_DS2431 |
| 20 | tristate "1kb EEPROM family support (DS2431)" |
| 21 | help |
| 22 | Say Y here if you want to use a 1-wire |
| 23 | 1kb EEPROM family device (DS2431) |
| 24 | |
| 25 | config W1_SLAVE_DS2433 |
| 26 | tristate "4kb EEPROM family support (DS2433)" |
| 27 | help |
| 28 | Say Y here if you want to use a 1-wire |
| 29 | 4kb EEPROM family device (DS2433). |
| 30 | |
| 31 | config W1_SLAVE_DS2433_CRC |
| 32 | bool "Protect DS2433 data with a CRC16" |
| 33 | depends on W1_SLAVE_DS2433 |
| 34 | select CRC16 |
| 35 | help |
| 36 | Say Y here to protect DS2433 data with a CRC16. |
| 37 | Each block has 30 bytes of data and a two byte CRC16. |
| 38 | Full block writes are only allowed if the CRC is valid. |
| 39 | |
| 40 | config W1_SLAVE_DS2760 |
| 41 | tristate "Dallas 2760 battery monitor chip (HP iPAQ & others)" |
| 42 | depends on W1 |
| 43 | help |
| 44 | If you enable this you will have the DS2760 battery monitor |
| 45 | chip support. |
| 46 | |
| 47 | The battery monitor chip is used in many batteries/devices |
| 48 | as the one who is responsible for charging/discharging/monitoring |
| 49 | Li+ batteries. |
| 50 | |
| 51 | If you are unsure, say N. |
| 52 | |
| 53 | config W1_SLAVE_BQ27000 |
| 54 | tristate "BQ27000 slave support" |
| 55 | depends on W1 |
| 56 | help |
| 57 | Say Y here if you want to use a hdq |
| 58 | bq27000 slave support. |
| 59 | |
| 60 | endmenu |