drivers/net/ethernet/hisilicon/Kconfig

   1 #
   2 # HISILICON device configuration
   3 #
   4
   5 config NET_VENDOR_HISILICON
   6         bool "Hisilicon devices"
   7         default y
   8         depends on (OF || ACPI) && HAS_DMA
   9         depends on ARM || ARM64 || COMPILE_TEST
  10         ---help---
  11           If you have a network (Ethernet) card belonging to this class, say Y.
  12
  13           Note that the answer to this question doesn't directly affect the
  14           kernel: saying N will just cause the configurator to skip all
  15           the questions about Hisilicon devices. If you say Y, you will be asked
  16           for your specific card in the following questions.
  17
  18 if NET_VENDOR_HISILICON
  19
  20 config HIX5HD2_GMAC
  21         tristate "Hisilicon HIX5HD2 Family Network Device Support"
  22         select PHYLIB
  23         help
  24           This selects the hix5hd2 mac family network device.
  25
  26 config HISI_FEMAC
  27         tristate "Hisilicon Fast Ethernet MAC device support"
  28         depends on HAS_IOMEM
  29         select PHYLIB
  30         select RESET_CONTROLLER
  31         help
  32           This selects the Hisilicon Fast Ethernet MAC device(FEMAC).
  33           The FEMAC receives and transmits data over Ethernet
  34           ports at 10/100 Mbps in full-duplex or half-duplex mode.
  35           The FEMAC exchanges data with the CPU, and supports
  36           the energy efficient Ethernet (EEE).
  37
  38 config HIP04_ETH
  39         tristate "HISILICON P04 Ethernet support"
  40         depends on HAS_IOMEM    # For MFD_SYSCON
  41         select MARVELL_PHY
  42         select MFD_SYSCON
  43         select HNS_MDIO
  44         ---help---
  45           If you wish to compile a kernel for a hardware with hisilicon p04 SoC and
  46           want to use the internal ethernet then you should answer Y to this.
  47
  48 config HNS_MDIO
  49         tristate
  50         select PHYLIB
  51         ---help---
  52           This selects the HNS MDIO support. It is needed by HNS_DSAF to access
  53           the PHY
  54
  55 config HNS
  56         tristate "Hisilicon Network Subsystem Support (Framework)"
  57         ---help---
  58           This selects the framework support for Hisilicon Network Subsystem. It
  59           is needed by any driver which provides HNS acceleration engine or make
  60           use of the engine
  61
  62 config HNS_DSAF
  63         tristate "Hisilicon HNS DSAF device Support"
  64         select HNS
  65         select HNS_MDIO
  66         ---help---
  67           This selects the DSAF (Distributed System Area Frabric) network
  68           acceleration engine support. The engine is used in Hisilicon hip05,
  69           Hi1610 and further ICT SoC
  70
  71 config HNS_ENET
  72         tristate "Hisilicon HNS Ethernet Device Support"
  73         select PHYLIB
  74         select HNS
  75         ---help---
  76           This selects the general ethernet driver for HNS.  This module make
  77           use of any HNS AE driver, such as HNS_DSAF
  78
  79 endif # NET_VENDOR_HISILICON