1 /* $Linux: hydra.h,v 1.0 1994/10/26 02:03:47 cgd Exp $ */
4 * Copyright (c) 1994 Timo Rossi
7 * Redistribution and use in source and binary forms, with or without
8 * modification, are permitted provided that the following conditions
10 * 1. Redistributions of source code must retain the above copyright
11 * notice, this list of conditions and the following disclaimer.
12 * 2. Redistributions in binary form must reproduce the above copyright
13 * notice, this list of conditions and the following disclaimer in the
14 * documentation and/or other materials provided with the distribution.
15 * 3. All advertising materials mentioning features or use of this software
16 * must display the following acknowledgement:
17 * This product includes software developed by Timo Rossi
18 * 4. The name of the author may not be used to endorse or promote products
19 * derived from this software without specific prior written permission
21 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
22 * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
23 * OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
24 * IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
25 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
26 * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
27 * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
28 * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
29 * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
30 * THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
34 * The Hydra Systems card uses the National Semiconductor
35 * 8390 NIC (Network Interface Controller) chip, located
36 * at card base address + 0xffe1. NIC registers are accessible
37 * only at odd byte addresses, so the register offsets must
38 * be multiplied by two.
40 * Card address PROM is located at card base + 0xffc0 (even byte addresses)
42 * RAM starts at the card base address, and is 16K or 64K.
43 * The current Amiga NetBSD hydra driver is hardwired for 16K.
44 * It seems that the RAM should be accessed as words or longwords only.
48 /* adapted for Linux by Topi Kanerva 03/29/95
49 with original author's permission */
51 #define HYDRA_NIC_BASE 0xffe1
55 #define NIC_CR 0 /* Command register */
56 #define NIC_PSTART (1*2) /* Page start (write) */
57 #define NIC_PSTOP (2*2) /* Page stop (write) */
58 #define NIC_BNDRY (3*2) /* Boundary pointer */
59 #define NIC_TSR (4*2) /* Transmit status (read) */
60 #define NIC_TPSR (4*2) /* Transmit page start (write) */
61 #define NIC_NCR (5*2) /* Number of collisions, read */
62 #define NIC_TBCR0 (5*2) /* Transmit byte count low (write) */
63 #define NIC_FIFO (6*2) /* FIFO reg. (read) */
64 #define NIC_TBCR1 (6*2) /* Transmit byte count high (write) */
65 #define NIC_ISR (7*2) /* Interrupt status register */
66 #define NIC_RBCR0 (0xa*2) /* Remote byte count low (write) */
67 #define NIC_RBCR1 (0xb*2) /* Remote byte count high (write) */
68 #define NIC_RSR (0xc*2) /* Receive status (read) */
69 #define NIC_RCR (0xc*2) /* Receive config (write) */
70 #define NIC_CNTR0 (0xd*2) /* Frame alignment error count (read) */
71 #define NIC_TCR (0xd*2) /* Transmit config (write) */
72 #define NIC_CNTR1 (0xe*2) /* CRC error counter (read) */
73 #define NIC_DCR (0xe*2) /* Data config (write) */
74 #define NIC_CNTR2 (0xf*2) /* missed packet counter (read) */
75 #define NIC_IMR (0xf*2) /* Interrupt mask reg. (write) */
79 #define NIC_PAR0 (1*2) /* Physical address */
80 #define NIC_PAR1 (2*2)
81 #define NIC_PAR2 (3*2)
82 #define NIC_PAR3 (4*2)
83 #define NIC_PAR4 (5*2)
84 #define NIC_PAR5 (6*2)
85 #define NIC_CURR (7*2) /* Current RX ring-buffer page */
86 #define NIC_MAR0 (8*2) /* Multicast address */
87 #define NIC_MAR1 (9*2)
88 #define NIC_MAR2 (0xa*2)
89 #define NIC_MAR3 (0xb*2)
90 #define NIC_MAR4 (0xc*2)
91 #define NIC_MAR5 (0xd*2)
92 #define NIC_MAR6 (0xe*2)
93 #define NIC_MAR7 (0xf*2)
95 /* Command register definitions */
97 #define CR_STOP 0x01 /* Stop -- software reset command */
98 #define CR_START 0x02 /* Start */
99 #define CR_TXP 0x04 /* Transmit packet */
101 #define CR_RD0 0x08 /* Remote DMA cmd */
105 #define CR_NODMA CR_RD2
107 #define CR_PS0 0x40 /* Page select */
111 #define CR_PAGE1 CR_PS0
112 #define CR_PAGE2 CR_PS1
114 /* Interrupt status reg. definitions */
116 #define ISR_PRX 0x01 /* Packet received without errors */
117 #define ISR_PTX 0x02 /* Packet transmitted without errors */
118 #define ISR_RXE 0x04 /* Receive error */
119 #define ISR_TXE 0x08 /* Transmit error */
120 #define ISR_OVW 0x10 /* Ring buffer overrun */
121 #define ISR_CNT 0x20 /* Counter overflow */
122 #define ISR_RDC 0x40 /* Remote DMA compile */
123 #define ISR_RST 0x80 /* Reset status */
125 /* Data config reg. definitions */
127 #define DCR_WTS 0x01 /* Word transfer select */
128 #define DCR_BOS 0x02 /* Byte order select */
129 #define DCR_LAS 0x04 /* Long address select */
130 #define DCR_LS 0x08 /* Loopback select */
131 #define DCR_AR 0x10 /* Auto-init remote */
132 #define DCR_FT0 0x20 /* FIFO threshold select */
135 /* Transmit config reg. definitions */
137 #define TCR_CRC 0x01 /* Inhibit CRC */
138 #define TCR_LB0 0x02 /* Loopback control */
140 #define TCR_ATD 0x08 /* Auto transmit disable */
141 #define TCR_OFST 0x10 /* Collision offset enable */
143 /* Transmit status reg. definitions */
145 #define TSR_PTX 0x01 /* Packet transmitted */
146 #define TSR_COL 0x04 /* Transmit collided */
147 #define TSR_ABT 0x08 /* Transmit aborted */
148 #define TSR_CRS 0x10 /* Carrier sense lost */
149 #define TSR_FU 0x20 /* FIFO underrun */
150 #define TSR_CDH 0x40 /* CD Heartbeat */
151 #define TSR_OWC 0x80 /* Out of Window Collision */
153 /* Receiver config register definitions */
155 #define RCR_SEP 0x01 /* Save errored packets */
156 #define RCR_AR 0x02 /* Accept runt packets */
157 #define RCR_AB 0x04 /* Accept broadcast */
158 #define RCR_AM 0x08 /* Accept multicast */
159 #define RCR_PRO 0x10 /* Promiscuous mode */
160 #define RCR_MON 0x20 /* Monitor mode */
162 /* Receiver status register definitions */
164 #define RSR_PRX 0x01 /* Packet received without error */
165 #define RSR_CRC 0x02 /* CRC error */
166 #define RSR_FAE 0x04 /* Frame alignment error */
167 #define RSR_FO 0x08 /* FIFO overrun */
168 #define RSR_MPA 0x10 /* Missed packet */
169 #define RSR_PHY 0x20 /* Physical address */
170 #define RSR_DIS 0x40 /* Received disabled */
171 #define RSR_DFR 0x80 /* Deferring (jabber) */
173 /* Hydra System card address PROM offset */
175 #define HYDRA_ADDRPROM 0xffc0
This page took 0.033428 seconds and 5 git commands to generate.