drivers/staging/solo6x10/TODO

   1 TODO (staging => main):
   2
   3         * checkpatch.pl (haven't run it yet)
   4         * Lindent (should be clean, but check)
   5         * Motion detection flags need to be moved to v4l2
   6         * Some private CIDs need to be moved to v4l2
   7
   8 TODO (general):
   9
  10         * encoder on/off controls
  11         * mpeg cid bitrate mode (vbr/cbr)
  12         * mpeg cid bitrate/bitrate-peak
  13         * mpeg encode of user data
  14         * mpeg decode of user data
  15         * switch between 4 frames/irq to 1 when using mjpeg (and then back
  16           when not)
  17         * implement a CID control for motion areas/thresholds
  18         * implement CID controls for mozaic areas
  19         * allow for higher level of interval (for < 1 fps)
  20         * sound:
  21           - implement playback via external sound jack
  22           - implement loopback of external sound jack with incoming audio?
  23           - implement pause/resume
  24           - check into jacking sound from tx28xx chips directly (to avoid
  25             g.723/8khz limitations)
  26
  27 Plase send patches to Greg Kroah-Hartman <greg@kroah.com> and Cc Ben Collins
  28 <bcollins@bluecherry.net>