include/linux/pinctrl/pinctrl-state.h

   1 /*
   2  * Standard pin control state definitions
   3  */
   4
   5 /**
   6  * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put
   7  *      into as default, usually this means the pins are up and ready to
   8  *      be used by the device driver. This state is commonly used by
   9  *      hogs to configure muxing and pins at boot, and also as a state
  10  *      to go into when returning from sleep and idle in
  11  *      .pm_runtime_resume() or ordinary .resume() for example.
  12  * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into
  13  *      when the pins are idle. This is a state where the system is relaxed
  14  *      but not fully sleeping - some power may be on but clocks gated for
  15  *      example. Could typically be set from a pm_runtime_suspend() or
  16  *      pm_runtime_idle() operation.
  17  * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into
  18  *      when the pins are sleeping. This is a state where the system is in
  19  *      its lowest sleep state. Could typically be set from an
  20  *      ordinary .suspend() function.
  21  */
  22 #define PINCTRL_STATE_DEFAULT "default"
  23 #define PINCTRL_STATE_IDLE "idle"
  24 #define PINCTRL_STATE_SLEEP "sleep"