include/linux/regulator/driver.h

   1 /*
   2  * driver.h -- SoC Regulator driver support.
   3  *
   4  * Copyright (C) 2007, 2008 Wolfson Microelectronics PLC.
   5  *
   6  * Author: Liam Girdwood <lrg@slimlogic.co.uk>
   7  *
   8  * This program is free software; you can redistribute it and/or modify
   9  * it under the terms of the GNU General Public License version 2 as
  10  * published by the Free Software Foundation.
  11  *
  12  * Regulator Driver Interface.
  13  */
  14
  15 #ifndef __LINUX_REGULATOR_DRIVER_H_
  16 #define __LINUX_REGULATOR_DRIVER_H_
  17
  18 #include <linux/device.h>
  19 #include <linux/regulator/consumer.h>
  20
  21 struct regulator_dev;
  22 struct regulator_init_data;
  23
  24 enum regulator_status {
  25         REGULATOR_STATUS_OFF,
  26         REGULATOR_STATUS_ON,
  27         REGULATOR_STATUS_ERROR,
  28         /* fast/normal/idle/standby are flavors of "on" */
  29         REGULATOR_STATUS_FAST,
  30         REGULATOR_STATUS_NORMAL,
  31         REGULATOR_STATUS_IDLE,
  32         REGULATOR_STATUS_STANDBY,
  33 };
  34
  35 /**
  36  * struct regulator_ops - regulator operations.
  37  *
  38  * @enable: Configure the regulator as enabled.
  39  * @disable: Configure the regulator as disabled.
  40  * @is_enabled: Return 1 if the regulator is enabled, 0 otherwise.
  41  *
  42  * @set_voltage: Set the voltage for the regulator within the range specified.
  43  *               The driver should select the voltage closest to min_uV.
  44  * @get_voltage: Return the currently configured voltage for the regulator.
  45  * @list_voltage: Return one of the supported voltages, in microvolts; zero
  46  *      if the selector indicates a voltage that is unusable on this system;
  47  *      or negative errno.  Selectors range from zero to one less than
  48  *      regulator_desc.n_voltages.  Voltages may be reported in any order.
  49  *
  50  * @set_current_limit: Configure a limit for a current-limited regulator.
  51  * @get_current_limit: Get the configured limit for a current-limited regulator.
  52  *
  53  * @set_mode: Set the configured operating mode for the regulator.
  54  * @get_mode: Get the configured operating mode for the regulator.
  55  * @get_status: Return actual (not as-configured) status of regulator, as a
  56  *      REGULATOR_STATUS value (or negative errno)
  57  * @get_optimum_mode: Get the most efficient operating mode for the regulator
  58  *                    when running with the specified parameters.
  59  *
  60  * @set_suspend_voltage: Set the voltage for the regulator when the system
  61  *                       is suspended.
  62  * @set_suspend_enable: Mark the regulator as enabled when the system is
  63  *                      suspended.
  64  * @set_suspend_disable: Mark the regulator as disabled when the system is
  65  *                       suspended.
  66  * @set_suspend_mode: Set the operating mode for the regulator when the
  67  *                    system is suspended.
  68  *
  69  * This struct describes regulator operations which can be implemented by
  70  * regulator chip drivers.
  71  */
  72 struct regulator_ops {
  73
  74         /* enumerate supported voltages */
  75         int (*list_voltage) (struct regulator_dev *, unsigned selector);
  76
  77         /* get/set regulator voltage */
  78         int (*set_voltage) (struct regulator_dev *, int min_uV, int max_uV);
  79         int (*get_voltage) (struct regulator_dev *);
  80
  81         /* get/set regulator current  */
  82         int (*set_current_limit) (struct regulator_dev *,
  83                                  int min_uA, int max_uA);
  84         int (*get_current_limit) (struct regulator_dev *);
  85
  86         /* enable/disable regulator */
  87         int (*enable) (struct regulator_dev *);
  88         int (*disable) (struct regulator_dev *);
  89         int (*is_enabled) (struct regulator_dev *);
  90
  91         /* get/set regulator operating mode (defined in regulator.h) */
  92         int (*set_mode) (struct regulator_dev *, unsigned int mode);
  93         unsigned int (*get_mode) (struct regulator_dev *);
  94
  95         /* report regulator status ... most other accessors report
  96          * control inputs, this reports results of combining inputs
  97          * from Linux (and other sources) with the actual load.
  98          * returns REGULATOR_STATUS_* or negative errno.
  99          */
 100         int (*get_status)(struct regulator_dev *);
 101
 102         /* get most efficient regulator operating mode for load */
 103         unsigned int (*get_optimum_mode) (struct regulator_dev *, int input_uV,
 104                                           int output_uV, int load_uA);
 105
 106         /* the operations below are for configuration of regulator state when
 107          * its parent PMIC enters a global STANDBY/HIBERNATE state */
 108
 109         /* set regulator suspend voltage */
 110         int (*set_suspend_voltage) (struct regulator_dev *, int uV);
 111
 112         /* enable/disable regulator in suspend state */
 113         int (*set_suspend_enable) (struct regulator_dev *);
 114         int (*set_suspend_disable) (struct regulator_dev *);
 115
 116         /* set regulator suspend operating mode (defined in regulator.h) */
 117         int (*set_suspend_mode) (struct regulator_dev *, unsigned int mode);
 118 };
 119
 120 /*
 121  * Regulators can either control voltage or current.
 122  */
 123 enum regulator_type {
 124         REGULATOR_VOLTAGE,
 125         REGULATOR_CURRENT,
 126 };
 127
 128 /**
 129  * struct regulator_desc - Regulator descriptor
 130  *
 131  * Each regulator registered with the core is described with a structure of
 132  * this type.
 133  *
 134  * @name: Identifying name for the regulator.
 135  * @id: Numerical identifier for the regulator.
 136  * @n_voltages: Number of selectors available for ops.list_voltage().
 137  * @ops: Regulator operations table.
 138  * @irq: Interrupt number for the regulator.
 139  * @type: Indicates if the regulator is a voltage or current regulator.
 140  * @owner: Module providing the regulator, used for refcounting.
 141  */
 142 struct regulator_desc {
 143         const char *name;
 144         int id;
 145         unsigned n_voltages;
 146         struct regulator_ops *ops;
 147         int irq;
 148         enum regulator_type type;
 149         struct module *owner;
 150 };
 151
 152 /*
 153  * struct regulator_dev
 154  *
 155  * Voltage / Current regulator class device. One for each
 156  * regulator.
 157  *
 158  * This should *not* be used directly by anything except the regulator
 159  * core and notification injection (which should take the mutex and do
 160  * no other direct access).
 161  */
 162 struct regulator_dev {
 163         struct regulator_desc *desc;
 164         int use_count;
 165         int open_count;
 166         int exclusive;
 167
 168         /* lists we belong to */
 169         struct list_head list; /* list of all regulators */
 170         struct list_head slist; /* list of supplied regulators */
 171
 172         /* lists we own */
 173         struct list_head consumer_list; /* consumers we supply */
 174         struct list_head supply_list; /* regulators we supply */
 175
 176         struct blocking_notifier_head notifier;
 177         struct mutex mutex; /* consumer lock */
 178         struct module *owner;
 179         struct device dev;
 180         struct regulation_constraints *constraints;
 181         struct regulator_dev *supply;   /* for tree */
 182
 183         void *reg_data;         /* regulator_dev data */
 184 };
 185
 186 struct regulator_dev *regulator_register(struct regulator_desc *regulator_desc,
 187         struct device *dev, struct regulator_init_data *init_data,
 188         void *driver_data);
 189 void regulator_unregister(struct regulator_dev *rdev);
 190
 191 int regulator_notifier_call_chain(struct regulator_dev *rdev,
 192                                   unsigned long event, void *data);
 193
 194 void *rdev_get_drvdata(struct regulator_dev *rdev);
 195 struct device *rdev_get_dev(struct regulator_dev *rdev);
 196 int rdev_get_id(struct regulator_dev *rdev);
 197
 198 int regulator_mode_to_status(unsigned int);
 199
 200 void *regulator_get_init_drvdata(struct regulator_init_data *reg_init_data);
 201
 202 #endif