1 #ifndef __LINUX_SPI_DS1305_H
2 #define __LINUX_SPI_DS1305_H
5 * One-time configuration for ds1305 and ds1306 RTC chips.
7 * Put a pointer to this in spi_board_info.platform_data if you want to
8 * be sure that Linux (re)initializes this as needed ... after losing
9 * backup power, and potentially on the first boot.
11 struct ds1305_platform_data
{
13 /* Trickle charge configuration: it's OK to leave out the MAGIC
14 * bitmask; mask in either DS1 or DS2, and then one of 2K/4k/8K.
16 #define DS1305_TRICKLE_MAGIC 0xa0
17 #define DS1305_TRICKLE_DS2 0x08 /* two diodes */
18 #define DS1305_TRICKLE_DS1 0x04 /* one diode */
19 #define DS1305_TRICKLE_2K 0x01 /* 2 KOhm resistance */
20 #define DS1305_TRICKLE_4K 0x02 /* 4 KOhm resistance */
21 #define DS1305_TRICKLE_8K 0x03 /* 8 KOhm resistance */
24 /* set only on ds1306 parts */
27 /* ds1306 only: enable 1 Hz output */
30 /* REVISIT: the driver currently expects nINT0 to be wired
31 * as the alarm IRQ. ALM1 may also need to be set up ...
35 #endif /* __LINUX_SPI_DS1305_H */
This page took 0.031805 seconds and 5 git commands to generate.