goto return_error;
}
+ /*
+ * Bail out earlier to let NAND_ECC_SOFT code create its own
+ * ecclayout instead of using ours.
+ */
+ if (info->ecc_opt == OMAP_ECC_HAM1_CODE_SW) {
+ nand_chip->ecc.mode = NAND_ECC_SOFT;
+ goto scan_tail;
+ }
+
/* populate MTD interface based on ECC scheme */
ecclayout = &info->oobinfo;
+ nand_chip->ecc.layout = ecclayout;
switch (info->ecc_opt) {
- case OMAP_ECC_HAM1_CODE_SW:
- nand_chip->ecc.mode = NAND_ECC_SOFT;
- break;
-
case OMAP_ECC_HAM1_CODE_HW:
pr_info("nand: using OMAP_ECC_HAM1_CODE_HW\n");
nand_chip->ecc.mode = NAND_ECC_HW;
ecclayout->oobfree->offset = 1 +
ecclayout->eccpos[ecclayout->eccbytes - 1] + 1;
/* software bch library is used for locating errors */
- nand_chip->ecc.priv = nand_bch_init(mtd,
- nand_chip->ecc.size,
- nand_chip->ecc.bytes,
- &ecclayout);
+ nand_chip->ecc.priv = nand_bch_init(mtd);
if (!nand_chip->ecc.priv) {
dev_err(&info->pdev->dev, "unable to use BCH library\n");
err = -EINVAL;
ecclayout->oobfree->offset = 1 +
ecclayout->eccpos[ecclayout->eccbytes - 1] + 1;
/* software bch library is used for locating errors */
- nand_chip->ecc.priv = nand_bch_init(mtd,
- nand_chip->ecc.size,
- nand_chip->ecc.bytes,
- &ecclayout);
+ nand_chip->ecc.priv = nand_bch_init(mtd);
if (!nand_chip->ecc.priv) {
dev_err(&info->pdev->dev, "unable to use BCH library\n");
err = -EINVAL;
goto return_error;
}
- if (info->ecc_opt == OMAP_ECC_HAM1_CODE_SW)
- goto scan_tail;
-
/* all OOB bytes from oobfree->offset till end off OOB are free */
ecclayout->oobfree->length = mtd->oobsize - ecclayout->oobfree->offset;
/* check if NAND device's OOB is enough to store ECC signatures */
err = -EINVAL;
goto return_error;
}
- nand_chip->ecc.layout = ecclayout;
scan_tail:
/* second phase scan */