* @rate: max rate in hz this chip supports
* @div_cpsr: cpsr (pre-scaler) divider
* @div_scr: scr divider
- * @dss: bits per word (4 - 16 bits)
* @ops: private chip operations
*
* This structure is used to store hardware register specific settings for each
unsigned long rate;
u8 div_cpsr;
u8 div_scr;
- u8 dss;
struct ep93xx_spi_chip_ops *ops;
};
/* converts bits per word to CR0.DSS value */
#define bits_per_word_to_dss(bpw) ((bpw) - 1)
-static inline void
-ep93xx_spi_write_u8(const struct ep93xx_spi *espi, u16 reg, u8 value)
+static void ep93xx_spi_write_u8(const struct ep93xx_spi *espi,
+ u16 reg, u8 value)
{
- __raw_writeb(value, espi->regs_base + reg);
+ writeb(value, espi->regs_base + reg);
}
-static inline u8
-ep93xx_spi_read_u8(const struct ep93xx_spi *spi, u16 reg)
+static u8 ep93xx_spi_read_u8(const struct ep93xx_spi *spi, u16 reg)
{
- return __raw_readb(spi->regs_base + reg);
+ return readb(spi->regs_base + reg);
}
-static inline void
-ep93xx_spi_write_u16(const struct ep93xx_spi *espi, u16 reg, u16 value)
+static void ep93xx_spi_write_u16(const struct ep93xx_spi *espi,
+ u16 reg, u16 value)
{
- __raw_writew(value, espi->regs_base + reg);
+ writew(value, espi->regs_base + reg);
}
-static inline u16
-ep93xx_spi_read_u16(const struct ep93xx_spi *spi, u16 reg)
+static u16 ep93xx_spi_read_u16(const struct ep93xx_spi *spi, u16 reg)
{
- return __raw_readw(spi->regs_base + reg);
+ return readw(spi->regs_base + reg);
}
static int ep93xx_spi_enable(const struct ep93xx_spi *espi)
chip->rate = spi->max_speed_hz;
}
- chip->dss = bits_per_word_to_dss(spi->bits_per_word);
-
ep93xx_spi_cs_control(spi, false);
return 0;
}
* ep93xx_spi_chip_setup() - configures hardware according to given @chip
* @espi: ep93xx SPI controller struct
* @chip: chip specific settings
+ * @bits_per_word: transfer bits_per_word
*
* This function sets up the actual hardware registers with settings given in
* @chip. Note that no validation is done so make sure that callers validate
* settings before calling this.
*/
static void ep93xx_spi_chip_setup(const struct ep93xx_spi *espi,
- const struct ep93xx_spi_chip *chip)
+ const struct ep93xx_spi_chip *chip,
+ u8 bits_per_word)
{
+ u8 dss = bits_per_word_to_dss(bits_per_word);
u16 cr0;
cr0 = chip->div_scr << SSPCR0_SCR_SHIFT;
cr0 |= (chip->spi->mode & (SPI_CPHA|SPI_CPOL)) << SSPCR0_MODE_SHIFT;
- cr0 |= chip->dss;
+ cr0 |= dss;
dev_dbg(&espi->pdev->dev, "setup: mode %d, cpsr %d, scr %d, dss %d\n",
- chip->spi->mode, chip->div_cpsr, chip->div_scr, chip->dss);
+ chip->spi->mode, chip->div_cpsr, chip->div_scr, dss);
dev_dbg(&espi->pdev->dev, "setup: cr0 %#x", cr0);
ep93xx_spi_write_u8(espi, SSPCPSR, chip->div_cpsr);
ep93xx_spi_write_u16(espi, SSPCR0, cr0);
}
-static inline int bits_per_word(const struct ep93xx_spi *espi)
-{
- struct spi_message *msg = espi->current_msg;
- struct spi_transfer *t = msg->state;
-
- return t->bits_per_word;
-}
-
static void ep93xx_do_write(struct ep93xx_spi *espi, struct spi_transfer *t)
{
- if (bits_per_word(espi) > 8) {
+ if (t->bits_per_word > 8) {
u16 tx_val = 0;
if (t->tx_buf)
static void ep93xx_do_read(struct ep93xx_spi *espi, struct spi_transfer *t)
{
- if (bits_per_word(espi) > 8) {
+ if (t->bits_per_word > 8) {
u16 rx_val;
rx_val = ep93xx_spi_read_u16(espi, SSPDR);
size_t len = t->len;
int i, ret, nents;
- if (bits_per_word(espi) > 8)
+ if (t->bits_per_word > 8)
buswidth = DMA_SLAVE_BUSWIDTH_2_BYTES;
else
buswidth = DMA_SLAVE_BUSWIDTH_1_BYTE;
struct spi_transfer *t)
{
struct ep93xx_spi_chip *chip = spi_get_ctldata(msg->spi);
+ int err;
msg->state = t;
- /*
- * Handle any transfer specific settings if needed. We use
- * temporary chip settings here and restore original later when
- * the transfer is finished.
- */
- if (t->speed_hz || t->bits_per_word) {
- struct ep93xx_spi_chip tmp_chip = *chip;
-
- if (t->speed_hz) {
- int err;
-
- err = ep93xx_spi_calc_divisors(espi, &tmp_chip,
- t->speed_hz);
- if (err) {
- dev_err(&espi->pdev->dev,
- "failed to adjust speed\n");
- msg->status = err;
- return;
- }
- }
-
- if (t->bits_per_word)
- tmp_chip.dss = bits_per_word_to_dss(t->bits_per_word);
-
- /*
- * Set up temporary new hw settings for this transfer.
- */
- ep93xx_spi_chip_setup(espi, &tmp_chip);
+ err = ep93xx_spi_calc_divisors(espi, chip, t->speed_hz);
+ if (err) {
+ dev_err(&espi->pdev->dev, "failed to adjust speed\n");
+ msg->status = err;
+ return;
}
+ ep93xx_spi_chip_setup(espi, chip, t->bits_per_word);
+
espi->rx = 0;
espi->tx = 0;
ep93xx_spi_cs_control(msg->spi, true);
}
}
-
- if (t->speed_hz || t->bits_per_word)
- ep93xx_spi_chip_setup(espi, chip);
}
/*
espi->fifo_level = 0;
/*
- * Update SPI controller registers according to spi device and assert
- * the chipselect.
+ * Assert the chipselect.
*/
- ep93xx_spi_chip_setup(espi, spi_get_ctldata(msg->spi));
ep93xx_spi_cs_control(msg->spi, true);
list_for_each_entry(t, &msg->transfers, transfer_list) {
info = pdev->dev.platform_data;
+ irq = platform_get_irq(pdev, 0);
+ if (irq < 0) {
+ dev_err(&pdev->dev, "failed to get irq resources\n");
+ return -EBUSY;
+ }
+
+ res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ if (!res) {
+ dev_err(&pdev->dev, "unable to get iomem resource\n");
+ return -ENODEV;
+ }
+
master = spi_alloc_master(&pdev->dev, sizeof(*espi));
- if (!master) {
- dev_err(&pdev->dev, "failed to allocate spi master\n");
+ if (!master)
return -ENOMEM;
- }
master->setup = ep93xx_spi_setup;
master->transfer = ep93xx_spi_transfer;
espi = spi_master_get_devdata(master);
- espi->clk = clk_get(&pdev->dev, NULL);
+ espi->clk = devm_clk_get(&pdev->dev, NULL);
if (IS_ERR(espi->clk)) {
dev_err(&pdev->dev, "unable to get spi clock\n");
error = PTR_ERR(espi->clk);
espi->min_rate = clk_get_rate(espi->clk) / (254 * 256);
espi->pdev = pdev;
- irq = platform_get_irq(pdev, 0);
- if (irq < 0) {
- error = -EBUSY;
- dev_err(&pdev->dev, "failed to get irq resources\n");
- goto fail_put_clock;
- }
-
- res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
- if (!res) {
- dev_err(&pdev->dev, "unable to get iomem resource\n");
- error = -ENODEV;
- goto fail_put_clock;
- }
-
espi->sspdr_phys = res->start + SSPDR;
espi->regs_base = devm_ioremap_resource(&pdev->dev, res);
if (IS_ERR(espi->regs_base)) {
error = PTR_ERR(espi->regs_base);
- goto fail_put_clock;
+ goto fail_release_master;
}
error = devm_request_irq(&pdev->dev, irq, ep93xx_spi_interrupt,
0, "ep93xx-spi", espi);
if (error) {
dev_err(&pdev->dev, "failed to request irq\n");
- goto fail_put_clock;
+ goto fail_release_master;
}
if (info->use_dma && ep93xx_spi_setup_dma(espi))
destroy_workqueue(espi->wq);
fail_free_dma:
ep93xx_spi_release_dma(espi);
-fail_put_clock:
- clk_put(espi->clk);
fail_release_master:
spi_master_put(master);
spin_unlock_irq(&espi->lock);
ep93xx_spi_release_dma(espi);
- clk_put(espi->clk);
spi_unregister_master(master);
return 0;