/* Target-dependent code for the HP PA-RISC architecture.
- Copyright (C) 1986-2015 Free Software Foundation, Inc.
+ Copyright (C) 1986-2017 Free Software Foundation, Inc.
Contributed by the Center for Software Science at the
University of Utah (pa-gdb-bugs@cs.utah.edu).
#include "gdbtypes.h"
#include "objfiles.h"
#include "hppa-tdep.h"
+#include <algorithm>
static int hppa_debug = 0;
static int
hppa_sign_extend (unsigned val, unsigned bits)
{
- return (int) (val >> (bits - 1) ? (-1 << bits) | val : val);
+ return (int) (val >> (bits - 1) ? (-(1 << bits)) | val : val);
}
/* For many immediate values the sign bit is the low bit! */
static int
hppa_low_hppa_sign_extend (unsigned val, unsigned bits)
{
- return (int) ((val & 0x1 ? (-1 << (bits - 1)) : 0) | val >> 1);
+ return (int) ((val & 0x1 ? (-(1 << (bits - 1))) : 0) | val >> 1);
}
/* Extract the bits at positions between FROM and TO, using HP's numbering
return 0;
}
-static const unsigned char *
-hppa_breakpoint_from_pc (struct gdbarch *gdbarch, CORE_ADDR *pc, int *len)
-{
- static const unsigned char breakpoint[] = {0x00, 0x01, 0x00, 0x04};
- (*len) = sizeof (breakpoint);
- return breakpoint;
-}
+constexpr gdb_byte hppa_break_insn[] = {0x00, 0x01, 0x00, 0x04};
+
+typedef BP_MANIPULATION (hppa_break_insn) hppa_breakpoint;
/* Return the name of a register. */
hppa64_dwarf_reg_to_regnum (struct gdbarch *gdbarch, int reg)
{
/* The general registers and the sar are the same in both sets. */
- if (reg <= 32)
+ if (reg >= 0 && reg <= 32)
return reg;
/* fr4-fr31 are mapped from 72 in steps of 2. */
if (reg >= 72 && reg < 72 + 28 * 2 && !(reg & 1))
return HPPA64_FP4_REGNUM + (reg - 72) / 2;
- warning (_("Unmapped DWARF DBX Register #%d encountered."), reg);
return -1;
}
/* Stack base address at which the first parameter is stored. */
CORE_ADDR param_end = 0;
- /* The inner most end of the stack after all the parameters have
- been pushed. */
- CORE_ADDR new_sp = 0;
-
/* Two passes. First pass computes the location of everything,
second pass writes the bytes out. */
int write_pass;
while (regnum > HPPA_ARG0_REGNUM - 8 && len > 0)
{
regcache_cooked_write_part (regcache, regnum,
- offset % 8, min (len, 8), valbuf);
- offset += min (len, 8);
- valbuf += min (len, 8);
- len -= min (len, 8);
+ offset % 8, std::min (len, 8), valbuf);
+ offset += std::min (len, 8);
+ valbuf += std::min (len, 8);
+ len -= std::min (len, 8);
regnum--;
}
/* Allocate the outgoing parameter area. Make sure the outgoing
parameter area is multiple of 16 bytes in length. */
- sp += max (align_up (offset, 16), 64);
+ sp += std::max (align_up (offset, 16), (ULONGEST) 64);
/* Allocate 32-bytes of scratch space. The documentation doesn't
mention this, but it seems to be needed. */
while (len > 0)
{
regcache_cooked_read_part (regcache, regnum, offset,
- min (len, 8), readbuf);
- readbuf += min (len, 8);
- len -= min (len, 8);
+ std::min (len, 8), readbuf);
+ readbuf += std::min (len, 8);
+ len -= std::min (len, 8);
regnum++;
}
}
while (len > 0)
{
regcache_cooked_write_part (regcache, regnum, offset,
- min (len, 8), writebuf);
- writebuf += min (len, 8);
- len -= min (len, 8);
+ std::min (len, 8), writebuf);
+ writebuf += std::min (len, 8);
+ len -= std::min (len, 8);
regnum++;
}
}
/* std,ma X,D(sp) */
if ((inst & 0xffe00008) == 0x73c00008)
- return (inst & 0x1 ? -1 << 13 : 0) | (((inst >> 4) & 0x3ff) << 3);
+ return (inst & 0x1 ? -(1 << 13) : 0) | (((inst >> 4) & 0x3ff) << 3);
/* addil high21,%r30; ldo low11,(%r1),%r30)
save high bits in save_high21 for later use. */
may be the first instruction of the prologue. If that happens, then
the instruction skipping code has a bug that needs to be fixed. */
if (post_prologue_pc != 0)
- return max (pc, post_prologue_pc);
+ return std::max (pc, post_prologue_pc);
else
return (skip_prologue_hard_way (gdbarch, pc, 1));
}
CORE_ADDR offset;
if ((inst >> 26) == 0x1c)
- offset = (inst & 0x1 ? -1 << 13 : 0)
+ offset = (inst & 0x1 ? -(1 << 13) : 0)
| (((inst >> 4) & 0x3ff) << 3);
else if ((inst >> 26) == 0x03)
offset = hppa_low_hppa_sign_extend (inst & 0x1f, 5);
struct frame_id *this_id)
{
struct hppa_frame_cache *info;
- CORE_ADDR pc = get_frame_pc (this_frame);
struct unwind_table_entry *u;
info = hppa_frame_cache (this_frame, this_cache);
info->base = get_frame_register_unsigned (this_frame, HPPA_SP_REGNUM);
- if (gdbarch_osabi (gdbarch) == GDB_OSABI_HPUX_SOM)
- {
- /* HPUX uses export stubs in function calls; the export stub clobbers
- the return value of the caller, and, later restores it from the
- stack. */
- u = find_unwind_entry (get_frame_pc (this_frame));
-
- if (u && u->stub_unwind.stub_type == EXPORT)
- {
- info->saved_regs[HPPA_PCOQ_HEAD_REGNUM].addr = info->base - 24;
-
- return info;
- }
- }
-
/* By default we assume that stubs do not change the rp. */
info->saved_regs[HPPA_PCOQ_HEAD_REGNUM].realreg = HPPA_RP_REGNUM;
{
struct gdbarch_tdep *tdep;
struct gdbarch *gdbarch;
-
- /* Try to determine the ABI of the object we are loading. */
- if (info.abfd != NULL && info.osabi == GDB_OSABI_UNKNOWN)
- {
- /* If it's a SOM file, assume it's HP/UX SOM. */
- if (bfd_get_flavour (info.abfd) == bfd_target_som_flavour)
- info.osabi = GDB_OSABI_HPUX_SOM;
- }
/* find a candidate among the list of pre-declared architectures. */
arches = gdbarch_list_lookup_by_info (arches, &info);
internal_error (__FILE__, __LINE__, _("bad switch"));
}
- set_gdbarch_breakpoint_from_pc (gdbarch, hppa_breakpoint_from_pc);
+ set_gdbarch_breakpoint_kind_from_pc (gdbarch, hppa_breakpoint::kind_from_pc);
+ set_gdbarch_sw_breakpoint_from_kind (gdbarch, hppa_breakpoint::bp_from_kind);
set_gdbarch_pseudo_register_read (gdbarch, hppa_pseudo_register_read);
/* Frame unwind methods. */
void
_initialize_hppa_tdep (void)
{
- struct cmd_list_element *c;
-
gdbarch_register (bfd_arch_hppa, hppa_gdbarch_init, hppa_dump_tdep);
hppa_objfile_priv_data = register_objfile_data ();
projects / deliverable / binutils-gdb.git / blobdiff