Commit | Line | Data |
---|---|---|
c42aa775 NF |
1 | #ifndef __LINUX_ATMEL_MCI_H |
2 | #define __LINUX_ATMEL_MCI_H | |
7d2be074 | 3 | |
8ca28610 HCE |
4 | #include <linux/types.h> |
5 | ||
2c96a293 | 6 | #define ATMCI_MAX_NR_SLOTS 2 |
965ebf33 | 7 | |
6b918657 HS |
8 | /** |
9 | * struct mci_slot_pdata - board-specific per-slot configuration | |
10 | * @bus_width: Number of data lines wired up the slot | |
11 | * @detect_pin: GPIO pin wired to the card detect switch | |
12 | * @wp_pin: GPIO pin wired to the write protect sensor | |
1c1452be | 13 | * @detect_is_active_high: The state of the detect pin when it is active |
76d55564 | 14 | * @non_removable: The slot is not removable, only detect once |
6b918657 HS |
15 | * |
16 | * If a given slot is not present on the board, @bus_width should be | |
17 | * set to 0. The other fields are ignored in this case. | |
18 | * | |
19 | * Any pins that aren't available should be set to a negative value. | |
965ebf33 HS |
20 | * |
21 | * Note that support for multiple slots is experimental -- some cards | |
22 | * might get upset if we don't get the clock management exactly right. | |
23 | * But in most cases, it should work just fine. | |
6b918657 HS |
24 | */ |
25 | struct mci_slot_pdata { | |
26 | unsigned int bus_width; | |
7d2be074 HS |
27 | int detect_pin; |
28 | int wp_pin; | |
1c1452be | 29 | bool detect_is_active_high; |
76d55564 | 30 | bool non_removable; |
7d2be074 HS |
31 | }; |
32 | ||
6b918657 HS |
33 | /** |
34 | * struct mci_platform_data - board-specific MMC/SDcard configuration | |
74465b4f | 35 | * @dma_slave: DMA slave interface to use in data transfers. |
6b918657 HS |
36 | * @slot: Per-slot configuration data. |
37 | */ | |
38 | struct mci_platform_data { | |
2635d1ba | 39 | struct mci_dma_data *dma_slave; |
2c96a293 | 40 | struct mci_slot_pdata slot[ATMCI_MAX_NR_SLOTS]; |
6b918657 HS |
41 | }; |
42 | ||
c42aa775 | 43 | #endif /* __LINUX_ATMEL_MCI_H */ |